The Ford Barn - View Single Post

ken ct · 09-07-2011, 04:27 PM

Did Mac install new inner caps or did you use your old ones.You can tell if their the right ones by installing 1 side and leave the other side open [no caps] Look through the contacts on the inner cap should line up with the blade of the rotor when you turn the toung by hand. They will almost touch on the way around.If not you have the wrong inner plates.Just hunting all possibilities.Rotor bakealite rotor must have like steps on it not smooth like earlier ones 36 and down. ken ct.

09-07-2011, 04:27 PM	#91
ken ct BANNED Join Date: May 2010 Location: stratford,ct Posts: 5,971	Re: 1937 No start Did Mac install new inner caps or did you use your old ones.You can tell if their the right ones by installing 1 side and leave the other side open [no caps] Look through the contacts on the inner cap should line up with the blade of the rotor when you turn the toung by hand. They will almost touch on the way around.If not you have the wrong inner plates.Just hunting all possibilities.Rotor bakealite rotor must have like steps on it not smooth like earlier ones 36 and down. ken ct.