Thread: 1937 No start
View Single Post
Old 09-07-2011, 03:54 PM   #88
FlatheadTed
Senior Member
 
FlatheadTed's Avatar
 
Join Date: May 2010
Location: Auckland
Posts: 4,700
Send a message via AIM to FlatheadTed
Default Re: 1937 No start

Car was starting and running then ,not starting when warm ( as a result of the coil or condensor ) After rebuild of dizy will not start at all . You should Swap out the distributor. bad or wrong rotor (37type ).or points timing .It did have a new faulty condenser put in it . ??

Car was starting and running fine - then - started to be hard to start and would start and run BUT then when warm would not start - SO I checked for fuel, air, spark and there was NO spark at all coming out of rotor / distributor - so I sent distributor out to VanPelts for overhaul - got it back and now will just pop thru carb - then I took dist. off of car and put in vice and ran aux. pwr to it and there was internmittent spark and it was orangish - so I swapped out condenser, which was new with dist. overhaul, and got nice steady bue / white spark - as you can see by my replies I am trying to keep updated as I try things out. Thanks.
__________________
http://www.flatheadted.com


Flathead Ted brake Floaters ,

Last edited by FlatheadTed; 09-07-2011 at 04:11 PM.
FlatheadTed is offline   Reply With Quote