The Ford Barn - View Single Post

koates · 09-20-2021, 08:41 AM

I reread your post and you say you fitted a new cut out. If it is a diode type and not a points type then it has to match the polarity of the car which should be POS GROUND. If it is the wrong polarity cut out you will get a short through it. Regards, Kevin.

09-20-2021, 08:41 AM	#20
koates Senior Member Join Date: May 2010 Location: Melbourne Australia. Posts: 2,079	Re: Electrical verification 32 Ford I reread your post and you say you fitted a new cut out. If it is a diode type and not a points type then it has to match the polarity of the car which should be POS GROUND. If it is the wrong polarity cut out you will get a short through it. Regards, Kevin.