The Ford Barn - View Single Post

51 MERC-CT · 01-30-2020, 08:55 AM

"won't go in" means what? With the .903 dim. shown it should fit into the lower bore.
Just how far does it "go in" ?
And if you are talking about the one with the .911 shaft, it's probably oversized.

01-30-2020, 08:55 AM	#2
51 MERC-CT Senior Member Join Date: May 2010 Location: East Hartford, Ct Posts: 5,898	Re: Aftermarket Dist Fit Issues "won't go in" means what? With the .903 dim. shown it should fit into the lower bore. Just how far does it "go in" ? And if you are talking about the one with the .911 shaft, it's probably oversized. __________________ DON'T RECALL DOING SOMETHING FOR MYSELF BASED ON SOMEONE ELSE'S LIKES OR DISLIKES Last edited by 51 MERC-CT; 01-30-2020 at 09:18 AM.