View Single Post
Old 07-04-2016, 10:44 AM   #5
Senior Member
Join Date: Dec 2013
Location: The Netherlands
Posts: 240
Default Re: fit splash shield/r.fender: help !

Originally Posted by Glenn C. View Post
None of the sheet metal components will ever fit correctly until you have established that you have a true and square frame, also with no sag in the area of the rear engine mounts. You must measure the frame from corner to corner to determine if the frame is square. The frame condition is your top priority now.
The frame is Ok Glenn, thank you. It is just that the sheet metal, especially the repro splash shields need a lot of bending to adjust to the original fenders. Strange !! I read from the Jury Standards they were bent at the ends from the beginning, but I not even have a workable picture ....

hazelhoff is offline   Reply With Quote