View Single Post
Old 09-27-2019, 04:11 PM   #55
40cpe
Senior Member
 
40cpe's Avatar
 
Join Date: May 2010
Location: Star, MS
Posts: 3,351
Default Re: No reverse BW R-10

If you have the rear lever in the "locked out" position you should not be able to turn the output shaft in any direction without moving the input shaft while in any gear except neutral. While in reverse the output shaft should not move without moving the input shaft, regardless of the lock out handle position.

When the transmission was apart, did you insert the sun gear into the planetary gear all the way to insure the teeth mesh? I've never heard of any mis-match of the two gears, but something is stopping them from meshing.
40cpe is offline   Reply With Quote