Re: Buyer beware on another repro part
Quote:
Originally Posted by SteveB31
Not all vendors sell the wrong screw for that application. We sell the right one and have for 40 years. Also, keep in mind many horn covers have had that screw tightened too much in the past pulling the horn motor cover in a bit making even the correct screw appear too short and cause it to short out the brush. Make sure your motor cover is flat and not pulled in around that screw.
Steve @ Bert’s
|
Good point Steve, and I believe the part in question came from Brattons. The Horn motor cover was not the problem, but I can see people tightening it way too tight like they need a seal.
__________________
"The more things change, the more they stay the same."
Last edited by chrs1961815; 08-23-2019 at 05:17 AM.
Reason: Error
|