View Single Post
Old 06-27-2018, 12:11 AM   #28
Art Newland
Senior Member
Art Newland's Avatar
Join Date: Mar 2016
Location: Lynden, WA
Posts: 1,407
Default Re: 8BA Flywheel/Clutch....I've Read TOO Much

I went ahead and made a drilling template from some .400 thick aluminum.

I made the holes .266, a snug fit for my 17/64 bit to drill the new holes and then .303 for a snug fit for 5/16-18 bolt.

It bolted up perfect to the mounting holes for the 11 inch pressure plate. Then I drilled (by hand) two of the holes for the 10 inch and bolted it down. All the others look lined up well, I'll finish drilling and tapping the others tomorrow.
Attached Images
File Type: jpg template ready to go.jpg (72.6 KB, 16 views)
File Type: jpg bolts in.jpg (56.5 KB, 17 views)
File Type: jpg hole alignment.jpg (43.4 KB, 16 views)
"whatever works!"
Art Newland is offline   Reply With Quote