View Single Post
Old 10-23-2017, 01:47 PM   #16
George Miller
Senior Member
 
George Miller's Avatar
 
Join Date: May 2010
Location: NC
Posts: 2,936
Default Re: Knocking after installing new flywheel

Quote:
Originally Posted by newshirt View Post
I don't see any evidence of scraping on the flywheel bolts or clutch pad. (see attached)

The ring gear looks to be up against the flywheel stop, and appears free of obstructions.

Do you think the flywheel bolts could be contacting the rear main (behind the flywheel flange)? I used the Snyder's flywheel mounting bolts and dowel retainer, as shown in the original post.
I never used any but original bolts, but it is real close. I would pull one out and look at the end of the bolt, that will tell you.
George Miller is offline   Reply With Quote