View Single Post
Old 10-22-2017, 05:02 PM   #10
Tom Endy
Senior Member
 
Tom Endy's Avatar
 
Join Date: May 2010
Location: Southern California
Posts: 2,440
Default Re: Knocking after installing new flywheel

An earlier post asked if you checked the adjustment of the fingers on the pressure plate. Attached is an article that addresses that subject. Pressure plates are supposed to come from the factory already adjusted, however, that is not always the case.

This adjustment should not be confused with the clutch pedal adjustment that controls the distance for the throw-out bearing.

When making the clutch finger adjustment of the pressure plate it is important that the mounting surface on the flywheel for the pressure plate be within spec at 1.123" as mentioned earlier.

Tom Endy
Attached Files
File Type: pdf clutch adj article.pdf (86.8 KB, 39 views)
Tom Endy is offline   Reply With Quote