The Ford Barn - View Single Post

Tom Wesenberg · 08-09-2015, 08:12 AM

I use the thin spanners to hold the axle bearing nuts while tightening the lock nuts on bicycles. The same would apply to motorcycles. A screw and wing nut through the center hole could keep them together in the tool box.

08-09-2015, 08:12 AM	#2
Tom Wesenberg Senior Member Join Date: May 2010 Location: Mpls, MN Posts: 27,582	Re: Spanners (not Model A) I use the thin spanners to hold the axle bearing nuts while tightening the lock nuts on bicycles. The same would apply to motorcycles. A screw and wing nut through the center hole could keep them together in the tool box. Last edited by Tom Wesenberg; 08-09-2015 at 12:37 PM.