Re: Flat 6
The outer ports (1 and 6) are exactly the same distance on the 200 cu in Falcon as the flat 6. The inner two (3 and 4) are within 1/8" each. The 2 and 5 are about 5/8" off each. There is a company in Tennessee (I'll have to look it up) that sells a plasma cut flat 6 flange. I cut off the Falcon flange, heat adjusted the #2 and #5 tubes, used some short sections of 1-1/4" u-bend pipes and welded it up. It turned out pretty nice. Again, if I can figure out how to post pictures I will.
|