Re: Maine Machine Shop to Replace wheel Bearing Races?
Hi Skidmarks,
You’ve got me curious about the “pilot”. Did you make a bung with a center hole that was hammered into the bearing end? I wonder if a large diameter cone at the tail stock would work. The cone to engage the ID of the bearing end.
Glenn
[QUOTE=skidmarks;1867090]You dont need a super large lathe. About a 18" swing. I ve done them with a carbide tool bit. Center the bell end in a 4 jaw chuck and made a pilot for the wheel bearing end. And dial it in. Takes longer to set it up then maching it
|