The Ford Barn - View Single Post

JBohannon · 06-08-2015, 07:08 PM

For the first time I am going to pull the pan on my 28 Model A and see what condition the bottom end is in. I am doing this for 2 reasons. At higher engine speeds I get a terrible vibration and it feels like engine is going to come apart. Also I have a bad rear seal leak. My compression is ok and the car runs ok but I think it is time I see what condition it is in. Any ideas on what I should look for when I get the pan pulled. Should I check for extreme looseness in the rods or use plastigage? Thanks for any help.

06-08-2015, 07:08 PM	#1
JBohannon Senior Member Join Date: Dec 2011 Posts: 180	Model A Lower end For the first time I am going to pull the pan on my 28 Model A and see what condition the bottom end is in. I am doing this for 2 reasons. At higher engine speeds I get a terrible vibration and it feels like engine is going to come apart. Also I have a bad rear seal leak. My compression is ok and the car runs ok but I think it is time I see what condition it is in. Any ideas on what I should look for when I get the pan pulled. Should I check for extreme looseness in the rods or use plastigage? Thanks for any help.