Quote:
Originally Posted by Mike Peters
Yes. Those old, era aftermarket front mount spring assemblies are too stiff, and so the hand crank will not line up with the front pulley when inserted through the hand crank guide over the front axle. The current original type front motor mount spring assemblies offered by vendors work well.
|
The springs that were in the front motor mount kit from Bratton's will not work at least for me,too stiff and would not compress enough to even get the nut on the bottom to start.Someone mentioned Bert's knew what was going on with this and had the correct springs.I figured like everything else it would be the same springs but they were not,slightly shorter and wire diameter slightly smaller,they said that they were closest to Ford blueprint and they worked great.Everything I have gotten from Bert's has been good either new parts or used original.