The Ford Barn - View Single Post

B-O-B · 11-04-2019, 01:01 PM

If that were me I would let the machinist provide all the parts needed. That way if anything goes wrong he cannot blame you. Just went thru that with a machine shop on my 47 flathead. After I installed the motor A valve broke & they had to me to replace all the valves that they purchased & pay me for my time. Just my $.02.

11-04-2019, 01:01 PM	#9
B-O-B Senior Member Join Date: May 2010 Location: Ft Mohave,Az Posts: 1,987	Re: flathead rebuild If that were me I would let the machinist provide all the parts needed. That way if anything goes wrong he cannot blame you. Just went thru that with a machine shop on my 47 flathead. After I installed the motor A valve broke & they had to me to replace all the valves that they purchased & pay me for my time. Just my $.02.