Quote:
Originally Posted by wbs
hello- my car in primative location--dirt floor shed[ cant roll motor lifft; not much room to roll car back]-- fire wall out is out- need to pull rusted trans for repairs--
i hope to raise motor slightly and move it forward a few inches ,enuf to clear trans shaft lengths
ques- does above sound feasible?
any other suggestions?
thank you as always
|
I just did a clutch job on a 30 Tudor and for the first time I removed the rear end instead of pulling the motor. It really went well, and was much easier then pulling the motor and everything that entailed. I just unhooked the two break rods up front (don't unhook at the rear) as they are really hard to hook up in the end. Then just move the rear end (without the wheels on) back just a few inches and the tranny and bell can come out together (I removed the tranny tower)