View Single Post
Old 11-04-2019, 01:39 AM   #7
Lawrie
Senior Member
 
Lawrie's Avatar
 
Join Date: May 2010
Location: Qld, Australia
Posts: 4,195
Default Re: Flathead Valve Adjusting Methods ??'s

I set them with out the springs on, before the crank and rods are in, no assylube on the cam, just eng oil, same in the bearings,
once set all the valves and followers go into a table with 1234etc inlet and exh marked,
all clearances checked after assembly with the springs in,then you only have to turn the motor two turns,
Lawrie
Lawrie is offline   Reply With Quote