Re: 36 Ford drag link orientation question
Well, I got the 37 pitman arm yesterday and tried it out tonight. It is about an inch longer but it also curves in in upward direction so it basically still hits the oil pan only at a higher point. It only can go on the box one way it seems, If I could flip it around I think it would actually work because then it would curve down and away from the oil pan instead of up and closer to the oil pan. Am I missing something or can this only go on the 1 way? Does anybody know the torque range for the pit-man arm castellated nut? I guess if it is not able to flip, I will re-install the original arm. The tie rod I am Torquing 40-50 lbs ft, is this correct?
Thanks...Dave
|