The Ford Barn - View Single Post - The Terry Burtz 5 main bearing engine blocks are back on track.

Terry Burtz, Calif · 03-23-2021, 07:11 PM

hardtimes,

The flywheel shown in the picture had a cast-iron center from a Model A flywheel, a bell section made from 356-T7 Aluminum, and a Model A ring gear that was drilled for attachment bolts. This is not a production item because of all the machine work needed.

The 30-pound production flywheels for the "new engine" are all cast iron and will be here in late April 2021. When they leave China, John Lampl (Allied Classics) will send out invoices. For ease of bookkeeping, you need to pay the invoice, and then John will notify the warehouse in Hawthorne to release the merchandise. The warehouse is not set up to receive cash payments.

03-23-2021, 07:11 PM	#277
Terry Burtz, Calif Senior Member Join Date: May 2010 Location: Campbell,CA, USA Posts: 321	Re: The Terry Burtz 5 main bearing engine blocks are back on track. hardtimes, The flywheel shown in the picture had a cast-iron center from a Model A flywheel, a bell section made from 356-T7 Aluminum, and a Model A ring gear that was drilled for attachment bolts. This is not a production item because of all the machine work needed. The 30-pound production flywheels for the "new engine" are all cast iron and will be here in late April 2021. When they leave China, John Lampl (Allied Classics) will send out invoices. For ease of bookkeeping, you need to pay the invoice, and then John will notify the warehouse in Hawthorne to release the merchandise. The warehouse is not set up to receive cash payments.