Sponsored Links (Register now to hide all advertisements)
Setting up as posted will work fine Flathead Ted suggests slightly under filling when gauge disconnected which will give you some gas on Empty which sounds like a good idea.
Calibration is by way of rods . My gauge works well but as I have a Bob Drake Tank, with the adaptor to allow fitment of the original gauge, it reads 3/4 full when full to the brim. The adaptor raises the gauge enough to upset the reading I can't seem to calibrate this error out .
My plan is to cut out the area that mounts the gauge from an old original tank and weld it into the Bob Drake tank. Hopefully this will fix the problem
Karl