[Marshall V. Daut]

V8COOPMAN -
Because it's a custom fabrication for our car based upon the photos Dave at Millworks studied, I would guess that's why there is no depiction of it in the Millworks catalog or webpage. Kind of a one-off thing.

Ideucev8 -
I assume it will be something like seen in your link, hopefully not as massive - and I sure hope it can be replaced with the body still in place. I realize vast projects like this are done when the chassis is bare, but we don't have much choice. The car was purchased all "restored" above the chassis, but butchered beneath. The damage to the frame/K-member is too massive and dangerous to leave in place. If we have to, we may need to remove the body. Do you guys think this can be installed from beneath without removing the body?

Marshall