View Single Post
Old 10-23-2017, 04:38 PM   #18
newshirt
Senior Member
 
newshirt's Avatar
 
Join Date: Jan 2011
Location: Colorado Springs
Posts: 868
Default Re: Knocking after installing new flywheel

I took some measurements:
1. Flywheel bolt length 0.820
2. Crank shaft end-play: 0.009
3. Old flywheel dowel retainer: 0.042
4. New flywheel dowel retainer: 0.035
5. Flywheel flange to bearing cap clearance: 0.049
6. Flywheel bolt extends beyond flywheel: .3750 (plus some extra when torqued down)
7. Flywheel flange width: .3950

Observations:
1. Ring gear is tight against flywheel, absolutely no gap
2. Two layers of masking tape on flywheel mounting bolt heads does not rub off on clutch disc springs
3. No scraping on ring gear
4. No scraping on flywheel housing
5. No scraping on bearing cap (but it may be too hard to see)
6. No scraping on bell housing


Do you think the big cotter pin at the bottom of the flywheel housing could cause it? It looked way too far away from the ring gear, and tight in the hole, but it did have a little scraping on the top which might have gotten there when I tried to remove the flywheel without first removing the cotter pin.
__________________
Ray White
newshirt is offline   Reply With Quote