Re: Harmon Collins build thread ...
A little sunday morning discussion , ( baby its cold outside at 2 degrees in Indy ) so glad i insulated this shop really well!!!
Looking at the unit on the bench the lower section below the line is the parts needed to make it the " Harmon Collins distributor . Someone asked if they could just "make" the parts , i would say "probably not" ...
From left to right
1- u shaped condensor mount to mount the condensors (one for each coil)
2-Point plate with Bendix Aircraft contacts mounted one set per coil
3-Cap clips ( 49-53 loadamatic )
4-distributor cam with everyother one ground off (machine ground )
5-Dual coil special rotor with carbon button on bottom
6-secondary ring with brass contact and secondary coil connection
7-Harmon collins ( no center bump inside ) also special cap assembly
8-two long screws to allow primary ignition hook up
9-upper left rotor adapter to allow special rotor to fit crab
We will massage and clean all these parts and adjust as we go .
Upper parts will be treated as usual........
|