Mart, understand, bearing was fine, the metal plate on front of motor mount must have held bearing in place. All individual bearings look good, no discolor, definitly did not lack lube. I am hoping the vibration I picked up was the clutch (really do not see how one little rivet could make it feel like a tire out of balance). Also, do not see the bearing causing the vibration. Will have to put back together and check. I think I will go back to garage and check to see if the drive shaft is tight "centered" in torque tube, thanks Bruce
.
Red paint around the part of motor mount and gasket that mates up to transmission, plate would have held bearing from falling apart "for a while" just dodged another bullet??
.
