Re: oil pressure
I cleaned the sludge from the valve chamber. It was not real bad, but definitely was needing cleaned. I had cleaned the pan previously and drove it around some, maybe 30 miles in sort trips, and then read here about cleaning the valve chamber. This of course is a new to me car. I am an old pro auto mechanic, but other than growing up learning to drive with dads 28AR, I never worked on them before. So now have got a 29 Tudor, am learning a lot, but still confused about a lot. I know if I need major workalike removing engine/trans/diff, I will need to take it to an expert, as I don't have the space or equipment anymore. But my question is, now that I have cleaned the valve chamber, could someone show me a picture of where the drain/feed holes to the mains are. I wiped the area out and blew it with high pressure air (made a mess) but not positive I cleared the holes. I did find a couple holes, and run a wire in them, but only seemed top go in an inch or so. Maybe the hole takes a turn?
|