The Ford Barn - View Single Post

jdl · 08-19-2010, 05:22 PM

It's been awhile since I did this, but I think you can use the old gear to drive on the spiral seal sleeve, put the sleeve on, then the old gear, then a piece of pipe against the old gear and tap it on. heat up the spiral sleeve first, have everything ready to go before the sleeve cools down. make sense?

08-19-2010, 05:22 PM	#13
jdl Senior Member Join Date: May 2010 Location: California Central Coast Posts: 931	Re: crank slinger????????? It's been awhile since I did this, but I think you can use the old gear to drive on the spiral seal sleeve, put the sleeve on, then the old gear, then a piece of pipe against the old gear and tap it on. heat up the spiral sleeve first, have everything ready to go before the sleeve cools down. make sense?