View Single Post
Old 09-16-2019, 06:20 PM   #13
TJP
Junior Member
 
Join Date: Jan 2013
Posts: 11
Default Re: 3 brush generator ????

Today discovered that the generator was actually putting 7.3 V into the cutout yet only 6.2 was coming out. I proceeded to remove the top of the cutout and found it was a solid state type with a circuit board, capacitors etc. So I am assuming the issue is with the cutout correct ??

I wish i had a better grasp of how the system works. I think I understand the 3rd brush adjustment but the cutout is what's confusing me
thanks
TJP
TJP is offline   Reply With Quote