View Single Post
Old 05-09-2019, 08:41 PM   #6
BillCNC
Senior Member
 
BillCNC's Avatar
 
Join Date: Aug 2017
Location: SoCal Desert
Posts: 426
Default Re: Rebuilt Steering Box Adjustment Question

Thanks guy's.

Well, I think my new shaft is bent.

I removed the steering column from the box/shaft.
Removed the sector shaft and housing.
Readjusted the the upper race.
Set the Box on the bench and propped up the shaft in a pillow like a cradle.

When rotating the shaft, the box wobbles around when turning the shaft, BUT, ... when I sight the shaft or roll it on the table, it appears it's possibly straight I just don't have any real way of checking for sure. If anything it might be bent where the worm and shaft meet.

Regards
Bill
BillCNC is offline   Reply With Quote