View Single Post
Old 03-23-2019, 09:34 AM   #16
Mike Peters
Senior Member
 
Mike Peters's Avatar
 
Join Date: Aug 2012
Location: South East Wisconsin
Posts: 1,279
Default Re: Gas shutoff valve

Benson: You are correct about pencil filters from vendors leaving some gas in the thank and then having to catch that last little bit whilst removing the shutoff valve.
Here's my home made pencil filters. Got the idea from another Model A buddy a couple years ago. You simply roll a piece of brass screen around the appropriate size drill bit to fit the intake side of the shutoff valve. Solder the seam and install in the shutoff. The tank will then drain the same as no pencil filter because there in no copper upright tube used as the commercial filters that you see in the catalogs. ALL the gas drains out and the screen stays put if you get the right diameter so it fits snugly in the shutoff. Gravity does the rest.
Attached Images
File Type: jpg 1-P1150486.JPG (248.7 KB, 82 views)
Mike Peters is offline   Reply With Quote