The Ford Barn - View Single Post

Rich in Tucson · 10-10-2010, 10:01 PM

Tom, if you get a chance, could you please post a sketch of the router bit profile cut in the edge of a board with rough dimensions and orientation? I was planning to grind my own bit but I will keep searching since they are out there. Thanks muchly.

10-10-2010, 10:01 PM	#4
Rich in Tucson Senior Member Join Date: May 2010 Location: Tucson, Arizona Posts: 374	Re: Plank Floorboards Tom, if you get a chance, could you please post a sketch of the router bit profile cut in the edge of a board with rough dimensions and orientation? I was planning to grind my own bit but I will keep searching since they are out there. Thanks muchly.