37 truck dashboard question
I have a 37 pickup ½ ton. There is a dashboard trim piece the length of the dash that goes over the windshield gear assembly. The trim piece has holes in it (does not look threaded) and the windshield frame has holes that align with the trim piece. Does anyone know how these holes where attached together? No room for a small bolt and nut setup. I don’t want to use a sheet metal screw because that seems like a bad way to connect the holes. Also if you’re familiar what I have, is there some type of gasket that goes between the trim piece and the windshield frame? FYI, I think the 35 and 36 trucks had the same setup. Thanks Tom
|