The Ford Barn - View Single Post

CWPASADENA · 06-09-2019, 10:46 AM

I use only one piece however, the good quality 2 piece if installed correctly and kept TIGHT will perform well.

I think most of the problems with the 2 piece design is poor quality of manufacture and not keeping them TIGHT.

It is true that a 2 piece is a lot easier to change in the car, but after tens of thousands of miles in a Model A, I have not had to change a crank pulley while the engine is in the car.

My experience and opinion,

Chris W.

06-09-2019, 10:46 AM	#2
CWPASADENA Senior Member Join Date: May 2010 Location: PASADENA, CA Posts: 1,884	Re: Two piece crank shaft pulley I use only one piece however, the good quality 2 piece if installed correctly and kept TIGHT will perform well. I think most of the problems with the 2 piece design is poor quality of manufacture and not keeping them TIGHT. It is true that a 2 piece is a lot easier to change in the car, but after tens of thousands of miles in a Model A, I have not had to change a crank pulley while the engine is in the car. My experience and opinion, Chris W.