11-29-2019, 05:28 PM
|
#1
|
Senior Member
Join Date: Nov 2017
Location: Knoxville, TN
Posts: 317
|
Some Questions........
1. Do my rear brakes lines look good? Anything you see that might be in the way or isnt acceptable?
2. the front cross-member where my finger is pointing. I was going to drill and tap a hole to hold the front brake line. Will this be a problem or interfere? I figured it would be tucked away down there and woulnt be visible...
3. The holes in the bottom of the lower frame rail in the front, what are these for? Can i use these holes to bolt brake line clamps?
4. The cowl to firewall gasket. Does this get cut off where the ridge ends? Does this sit on the ridge as in the pic? Do i need to glue this in place so it doesnt move?
5. In my firewall grommet kit i have a few pcs that im not sure what they are for?
6. Is there a way to test a brake light switch or do they just last "forever"?
Last edited by Ian1932; 11-29-2019 at 06:16 PM.
|
|
|