View Single Post
Old 09-13-2019, 07:00 AM   #7
Mart
Senior Member
 
Mart's Avatar
 
Join Date: May 2010
Location: Solihull, England.
Posts: 8,732
Default Re: Turn Signal Switch with Relays

As the flasher relay needs two bulbs to flash at the correct rate, I'd be inclined to wire it as normal and then see if the circuit will also pull in a relay and flash at the correct rate. If it does, any number of extra bulbs can be ran off the relay.

A hazard flasher will run 4 bulbs. Is a suitable 6V hazard flasher unit available? If so that might be a way forward.

Mart.
Mart is offline   Reply With Quote