View Single Post
Old 02-11-2021, 07:00 PM   #28
cas3
Senior Member
 
Join Date: Jan 2011
Location: sw minnesota
Posts: 2,905
Default Re: Changing a 36 steering box for a 37

if you raise you're press to accommodate the long shaft, be very careful, it can bend easy. my press is to big to raise up so i made these tools to do the job in the vise using a good 2 jaw puller for both on and off procedures. in this photo i am in the press as i had a cut off shaft like you, but normally in the vice you need the aluminum block to hold it, a chunk of heavy steel with a hole thru to pull from, and your little tool that goes in the shaft
Attached Images
File Type: jpg IMG_1088.jpg (65.5 KB, 38 views)
cas3 is offline   Reply With Quote