This is what the original 39 LZ welting looks like, held on skirt with brass rivets :
.
.
Don came up with using Model A fender welting, he used spray adhesive, he laid out he welting around skirt ( held in place with cloths pin clamps) and cut out the fender skirt alignment pins and attachment latch. Sprayed both the fender skirt and welting, let it tack up and then installed on the skirt. He trimmed the excess width towards tire off with an exacto razor knife. It is a real learning experience to be with him, so much knowledge to get job done. Oh yeah, it looks GOOD!