Re: Turn signals but keeping single element bulb
Okay guys. I now have turn signals using the factory marker housings up front. Attached are pics of the sockets used. The sockets from C&G wouldnt work after I pressed them into place in the old socket housings.
I don't know if it was the sockets or something I did pressing them. Whatever the cause the spring loaded bottom would not come after pushed down.
I used new plastic sockets and attached them to the old housings.
It was a simple straightforward job as long I read and followed the directions with the turn signal switch.
I am however getting to old and fat to keep worming my self under the dash doing wiring.
All wiring went through the firewall with the factory wires. So everything under the hood cleaned pretty nice. I still have some ziptieing to do. But all in all I'm pleased with the outcome.
|