Is there a way to measure and make sure I get the correct one? I will look mine over for stamped part numbers. Didn't look at them that close for numbers. Frame vin # is 181205754. Most all Brewster were built on the 1934 frame but I will try to check the numbers and make sure.
Quote:
Originally Posted by JM 35 Sedan
The later 35-48 gears will not work in a 32-34 rear unless some machining is done on the ring and pinion gears. Plus the splined end of the pinion is too long which would require the pinion or the driveshaft to be shortened.
|