View Single Post
Old 06-15-2019, 02:03 PM   #8
bigd1101
Senior Member
 
bigd1101's Avatar
 
Join Date: Aug 2018
Location: Ithaca
Posts: 205
Default Re: Best way to scuff a clean head

Quote:
Originally Posted by Brian T View Post
In addition to what Paul said, invariably some junk will fall into the water jackets and cylinders, when finished cleaning wipe some grease on the cylinder walls and crank the engine over by hand then any dirt will stick to the grease and can be wiped out.
When the head is on and plugs installed, I flush the block by removing the water inlet and flush down thru the outlet to remove any gasket particles which would end up in the radiator.
I see it mentioned often that Graphite gaskets are difficult to remove, using a gasket or decal remover softens them up making this a easy job, this type of gasket as been used for many years.

Just saw your post about the 5.5 head, you and the old girl are going to like it.

Will do. I have a Gano filter on the outlet but will flush the jacket first. The Gano will catch any stray stuff before it reaches the radiator once the car is running.
bigd1101 is offline   Reply With Quote