The Ford Barn - View Single Post - continuation of Betsy's thread-stuck engine

ronn · 09-07-2013, 08:45 PM

Thanks Glenn, was out there playing today- the patience part is tough

was able to get 4 of the 8 lifters turning, by putting a very small pair of vice grips on them and swiveling them back and forth with PB Blaster
was going to buy the acetone, but almost 20. bucks a gallon, thought I'ld start with the PB
the valves are still pretty locked up and this could take awhile-cylinder #3 is still not running clear of the atf and gas I mixed 50/50
hoping when that cylinder clears, may get a little movement from the crank....

09-07-2013, 08:45 PM	#11
ronn Senior Member Join Date: Feb 2011 Location: NNNNNNNNJJJJJJJJJJ Posts: 6,796	Re: continuation of Betsy's thread-stuck engine Thanks Glenn, was out there playing today- the patience part is tough was able to get 4 of the 8 lifters turning, by putting a very small pair of vice grips on them and swiveling them back and forth with PB Blaster was going to buy the acetone, but almost 20. bucks a gallon, thought I'ld start with the PB the valves are still pretty locked up and this could take awhile-cylinder #3 is still not running clear of the atf and gas I mixed 50/50 hoping when that cylinder clears, may get a little movement from the crank....