The Ford Barn - View Single Post

J Franklin · 05-26-2020, 10:35 AM

Did you look into the coil to see if there is an old wire end clip that was stuck in there by accident? That might cause the new one to not seat. Usually the clip ends grip very tightly into the coil.

05-26-2020, 10:35 AM	#11
J Franklin Senior Member Join Date: May 2010 Location: Oregon Posts: 5,963	Re: Ignition wire falls out Did you look into the coil to see if there is an old wire end clip that was stuck in there by accident? That might cause the new one to not seat. Usually the clip ends grip very tightly into the coil.