I got a rebuild kit from Renners (flow tested jets) along with an original Venturi that was media blasted. I got a Venturi puller from Snyder's along with a new manufactured Venturi. The venturis had differences in size so I went with the original. It was hard to get both sides pulled and I had to take a punch and knock the edges off one side before it would pull it out and it was pancaking it.
I did go full retard and over tighten one of the jets and twisted it off
. I got the piece out without any trouble and will order a new one as it's hole is smaller than the one that was in the carburetor.
Overall it was pretty easy and I'd recommend that most of you could do it if I can. Of course I haven't tried to start the car yet. If you have any questions ask and I'll try to answer them.
Snyders is super fast on the shipping. It's like the order shows up as soon as I hit submit order. I placed this order two days after a brattons order and the Brattons still isn't here.
Oh,,,,, thank you to everyone who offered help or advice.