Thread: wheel studs
View Single Post
Old 07-16-2019, 02:18 PM   #6
coolcoupe
Senior Member
 
coolcoupe's Avatar
 
Join Date: May 2010
Location: ontario,Canada
Posts: 355
Default Re: wheel studs

These studs were not swedge in, but had a tack of well on the inside of the drum to prevent them from turning. I grinded that well of and they pressed the old studs out and pressed the new studs into the hubs. Then added a few tacks of well to prevent them from turning. Could the wells be causing this shimmy in the steering wheel ? I will check all of ideas you's have mentioned. Thanks for now, Moe
coolcoupe is offline   Reply With Quote