View Single Post
Old 08-31-2018, 11:05 AM   #7
30 Closed Cab PU
Senior Member
 
Join Date: Aug 2018
Posts: 2,332
Default Re: Nu-rex Timing wrench

Quote:
Originally Posted by duke36 View Post
Found it degrees off for 6.1 head to get enough retard and not worth the expense. Take a bulb and solder 2 pigtail alligator leads to it as a test lamp and connect leads to point arm and ground for fast / accurate timing.. The vendors offset cam wrench works well.

Thanks for the info. Already ordered it, only a few bucks. Currently use meter with a buzzer across the points. Buzzes, stops buzzing when point open. Prefer this so I do not have to constantly check a bulb. Do the buzzer 1st, then check the adjust with the wrench. Figure if the Nu wrench is off, modify it's handle material - remove material or add(jb weld it) a washer at the check spot on handle at the check point.
30 Closed Cab PU is offline   Reply With Quote