The Ford Barn - View Single Post

Gary WA · 04-22-2020, 04:09 PM

The shaft ends are offset, place in hole and turn cam nut on dist. till it drops in place doesn't matter about top dead center piston, just turn till drops in place. remove shaft and see if it sets in place? Maybe the pin diameter is larger.or something in the pin hole

04-22-2020, 04:09 PM	#3
Gary WA Senior Member Join Date: May 2010 Location: Clinton,WA/Whidbey Island Posts: 4,101	Re: Problem installing distributor The shaft ends are offset, place in hole and turn cam nut on dist. till it drops in place doesn't matter about top dead center piston, just turn till drops in place. remove shaft and see if it sets in place? Maybe the pin diameter is larger.or something in the pin hole __________________ www.whidbeymodelaclub.com Last edited by Gary WA; 04-22-2020 at 04:44 PM.