The Ford Barn - View Single Post

big job · 04-04-2015, 04:36 AM

Mouse power? Heres a good one In an auction I bought a 1956 T800 one owner
never seen asphalt original tubless tires power steering 4,000 mile truck ok thats
a little history. 332 Y block 5 & a 4 (OD). Clutch disk stuck. From experience only
fix for a stuck clutch is loosen pressure bolts. So I pull the clutch pan and holy
smokes, you know that expanding foam you buy, well thats what it looked like.
Big question is how in hell can a rat get in there ? Most flywheel pans only have a
1/8 or so weep hole in the bottom as this one. Mouse/ rat same to me, going through
that little hole is impossible or is it. These truck bellhousings have a louvered small
vent on the top, louvers are about 3/16 still to small to squeeze through or does
the rat have rubber bones?????? I dont know.

04-04-2015, 04:36 AM	#14
big job Senior Member Join Date: Sep 2013 Location: Dighton, Mass Posts: 1,230	Re: using pressurized oil pot Mouse power? Heres a good one In an auction I bought a 1956 T800 one owner never seen asphalt original tubless tires power steering 4,000 mile truck ok thats a little history. 332 Y block 5 & a 4 (OD). Clutch disk stuck. From experience only fix for a stuck clutch is loosen pressure bolts. So I pull the clutch pan and holy smokes, you know that expanding foam you buy, well thats what it looked like. Big question is how in hell can a rat get in there ? Most flywheel pans only have a 1/8 or so weep hole in the bottom as this one. Mouse/ rat same to me, going through that little hole is impossible or is it. These truck bellhousings have a louvered small vent on the top, louvers are about 3/16 still to small to squeeze through or does the rat have rubber bones?????? I dont know.