The Ford Barn - View Single Post

jrvariel48 · 04-18-2019, 06:52 AM

So after a lot of research, Mike from Ram clutches set me up with a compatible 10.5" pressure plate, clutch and bearing. It's part number 88761HDX. The throwout bearing is the smaller diameter Chevy style which will be installed the way TomT did his. The original flywheel will have to be redrilled and tapped. The Centerforce seemed to be overkill and on the expensive side. Wilcap and Southbend weren't able to help.
Thanks for the reply's! Joe

04-18-2019, 06:52 AM	#17
jrvariel48 Senior Member Join Date: Jan 2012 Location: New Jersey Posts: 1,427	Re: Diaphragm Pressure Plate So after a lot of research, Mike from Ram clutches set me up with a compatible 10.5" pressure plate, clutch and bearing. It's part number 88761HDX. The throwout bearing is the smaller diameter Chevy style which will be installed the way TomT did his. The original flywheel will have to be redrilled and tapped. The Centerforce seemed to be overkill and on the expensive side. Wilcap and Southbend weren't able to help. Thanks for the reply's! Joe