The Ford Barn - View Single Post - discussion on way to make a press for stainless to hubcap dish

RalphM · 12-10-2019, 10:24 AM

If the edge has t been “messed with” then the original shape will hold it on. What I’m saying is if it was removed with air vs a screwdriver. If the edge has been pried off then you will need some sort of tool to reshape the edge.

12-10-2019, 10:24 AM	#5
RalphM Senior Member Join Date: Nov 2015 Location: North Pole, Alaska Posts: 2,651	Re: discussion on way to make a press for stainless to hubcap dish If the edge has t been “messed with” then the original shape will hold it on. What I’m saying is if it was removed with air vs a screwdriver. If the edge has been pried off then you will need some sort of tool to reshape the edge.