The Ford Barn - View Single Post

Ol' Ron · 10-02-2019, 10:27 AM

Before I had a Bearing mic, I too, used the wrist pin method. But I never thought that was very accurate . This morning I used a magnifier hat and a light to read the mic, and that works very well, Your not going to believe this, but I have several hundred used bearings. So getting the right clearance was easy. Unfortunately, that was many years ago.

10-02-2019, 10:27 AM	#14
Ol' Ron Senior Member Join Date: May 2010 Location: Chester Vt Posts: 8,855	Re: Bearing dimentions Before I had a Bearing mic, I too, used the wrist pin method. But I never thought that was very accurate . This morning I used a magnifier hat and a light to read the mic, and that works very well, Your not going to believe this, but I have several hundred used bearings. So getting the right clearance was easy. Unfortunately, that was many years ago.